Heatsinks for DMK, Basler, Flea Type Cameras
These black anodized aluminum heatsinks peel-and-stick to the
sides of your DMK, Basler, Flea type cameras. The long fins provide
lots of surface area to dissipate much of the heat those little
buggers generate, especially at high frame rates and high gain
settings. 1-3/8" square, 5/8" long fins, with a thermal adhesive
tape.
Clean the sizes of the camera with the supplied alchohol wipe, let
dry, peel and stick the heatsinks, then lightly clamp the heatsinks
in place or balance a book on them for a couple of hours for the
adhesive to set. The heatsinks are a bit taller than the qube cameras
so I recommend mounting them flush to the top of the camera.
Camera must have flat sides!
Imagine your camera nestled between these:
(Don't have a picture yet...)
Prices include shipping in the USA!
Ordering Information
ScopeStuff Home
